Please select your home edition
Edition
Zhik 2024 March - LEADERBOARD

A-Class Worlds- Emirates Team NZ sailors a class above the rest

by Kerry Ellis on 17 Feb 2014
Glenn Ashby (AUS) Int. A-Class Catamaran World Championship, Day 5, Takapuna NZ Richard Gladwell www.photosport.co.nz

The final day of racing scheduled in the A Class Catamaran World Championships was basically a drifter when the crews arrived at the Takapuna Boating club this morning.

There was one race for the final day, but after waiting on the water for an hour the committee called the boats back to the beach to wait for some breeze.

As seems to be always the case, once the boats hit the beach the fingers of breeze extended towards the shore, finally allowing enough wind to convince the race committee to call for a start.

The sailors were ready and charged for the final race, with the eagerness causing more than half the fleet to be over the line early; triggering a recall. The second start saw the black flag flying, leaving no room for error. The fleet made a more cautious start toward the pin end, sailing out toward the left hand side of the course.


Ashby was among the leaders off the line followed by Tuke and Burling looking for wind in toward the shore before heading out to the middle of the course. By the top mark Ashby had secured the lead. At the first bottom mark it was still Ashby followed by Peter Melvin and Blair Tuke. Most of the fleet appeared to favour the shore and left side of the course following Glenn Ashby.

Peter Burling, Blair Tuke and Nathan Outteridge took the right hand side of the course on the final beat hoping for a wind shift to allow them to make a significant gain on Glenn Ashby. The wind shifted some 120 degrees and in the end the right paid dividends, compressing the frontrunners, and giving many a chance by the final top mark. Glenn Ashby had a bad gybe at the top mark and left the door open for Nathan Outteridge to pass on the run home.


Nathan Outerridge crossed ahead of Glenn Ashby from Ray Davies and Blair Tuke. Nathan Outerridge had built his reputation for being a master in light conditions and displayed his immense talent by foiling across the line to a round of Australian Cheering.

The final race results do little to upset the leader board, and if anything go on to cement the three top racers in their podium places. The 2014 A-Class World Champion is Glenn Ashby (AUS), second is Blair Tuke (NZL) with Peter Burling (NZL) in third.

Most notable perhaps is the fact that four of the top five overall places are all members of the America’s cup syndicate Emirates Team New Zealand.

Glen Ashby said at the finish;
'It’s one from the best world championships I’ve been to from the point of view of all the new technology introduced to the class and the ideas from people from all over the world here at the regatta.'





Provisional Results of World Championship Placings:
Glenn Ashby (13)
Blair Tuke (30)
Peter Burling (40)
Andrew Landenberger (42)
Ray Davies (49)
Nathan Outteridge (53)
Scott Andersen (54)

Sydney International Boat Show 2024Hyde Sails 2022 One Design FOOTERNavico AUS Zeus3S FOOTER

Related Articles

Zhik kits out Australia's Olympic sailors
With industry-first high-performance neoprene-free wetsuit When Australia's 12 Olympic sailors take to the waters of Marseille in July this year, they'll wear the industry's first high-performance, neoprene-free wetsuits created by Sydney sailing apparel company Zhik.
Posted on 1 May
Holcim-PRB sustains bowsprit damage
Nicolas Lunven continues racing towards New York While in fifth position in The Transat CIC fleet, Team Holcim-PRB skipper Nicolas Lunven alerted his shore team on Wednesday morning that the boat's bowsprit had broken. The incident occurred overnight amid strong wind conditions.
Posted on 1 May
Momentous day for INEOS Britannia
As AC75 sets sail for first time INEOS Britannia's new race boat for the 37th America's Cup has set sail for the very first time. The British Challenger's AC75 took to the water in Barcelona with Olympic Gold medallists Sir Ben Ainslie and Giles Scott at the Helm on Wednesday 1st May.
Posted on 1 May
FlyingNikka is ready to fly again
Set to get back in the water for a new season of regattas Three appointments are planned for what is to all extents and purposes the first yacht in a new generation of full foiling regatta sailing boats, starting from the Spring Regattas held next weekend in Portofino, Liguria.
Posted on 1 May
52 Super Series PalmaVela Sailing Week Day 4
A thrilling Thursday title tussle is on the cards after no racing was possible Wednesday A thrilling Thursday title tussle is on the cards after no racing was possible Wednesday at the 52 SUPER SERIES PalmaVela Sailing Week due to very strong winds on Mallorca's world renowned Bay of Palma.
Posted on 1 May
PlanetSail Episode 31: New Cup boats
With records and drama down under It's been a big month for the America's Cup as four of the six teams unveiled their brand new AC75s. Years of development work and close to 100,000 hours of build time, there is plenty riding on each of these new launches.
Posted on 1 May
Transat CIC day 4
Charlie Dalin and Yoann Richomme continue to lead in the Atlantic On The Transat CIC solo race across the North Atlantic from Lorient to New York, there are close duels at the top of both the IMOCAs and Class40s.
Posted on 1 May
Henri-Lloyd New Arrival: Dri Fast Polo
Designed to perform for long days in the sun, on or off shore Created by Henri-Lloyd 30 years ago, the DRI FAST Polo has become an industry staple. Clean and smart, the DRI FAST Polo is an extremely comfortable, quick drying polo, with added UV protection.
Posted on 1 May
Cup Spy May 1: Kiwis call it quits
Emirates Team NZ have confirmed that they have finished sailing in NZ and are headed for Barcelona Emirates Team New Zealand has concluded their first sailing bloc, on May Day in Auckland. The America's Cup champions got away to an early start, in the face of a forecast of a freshening breeze, and finished sailing just after midday.
Posted on 1 May
XR 41 hull plug in the making!
Get an exclusive behind-the-scenes look at the making of the XR 41 Get an exclusive behind-the-scenes look at the making of the XR 41, as the hull plug is being CNC machined with high precision and expertise at Nedcam in Holland.
Posted on 1 May