Please select your home edition
Edition
Doyle_SailWorld_728X90px_GP TOP

18ft Skiffs: Hugh Treharne, a great Australian sailing talent

by Frank Quealey 11 Jul 2020 23:47 PDT

Hugh Treharne is one of Australia's greatest sailors. He was tactician on The America's Cup-winning Australia II in 1983, a renowned 16ft and 18ft Skiff sailor, a widely recognised sailmaker and a world champion blue water yachtsman. In acknowledgement of his marvellous achievements, Hugh was inducted into The Boating Industry Hall of Fame in 2013.

At only 19-years-old, Hugh was approached by Dennis Fox to sail his family's five handed 18 Footer The Fox. He teamed with his brothers Ian and David, Kevin Flower and John Longmuir, and finished runner up to Ken Beashel's Schemer at the 1963 Giltinan world Championship at Auckland in 1963.

Hugh recalls "it was a big learning curve, but a great experience. During the regatta, we even put loops on the gunwale and I got to sail from the trapeze, which wasn't common at the time. In the final race we even tried sailing the boat as a four-hander."

In 1969, a Sydney radiologist named Dr. Sam Hatfield was interested in owning an 18ft Skiff and wanted to name it to Thomas Cameron to honour a family friend. One condition was that Sam (a fit and strong 60-year-old) also wanted to be a part of the crew.

Hugh Treharne agreed to the offer and assembled the other crew members, who were mates from the North Harbour Sailing Club. Kevin Flower, who sailed with Treharne in the 1963 JJ Giltinan World Championship, was the forward hand, and Allan Walker, who had just returned from crewing in the Soling World Championship in Copenhagen, became the main sheet.

Once the crew had been settled, Treharne engaged his long-time friend Hugh Cooke to discuss the design of the new boat.

Cooke, with input from Kevin Flower, decided that the boat would be built along the design of reigning world champion Travelodge, but would be altered by making the bow sections finer, a bit more spring in the waterline and a more pleasing sheer line. Renowned boat builder Ian Peden, assisted by Ian Perdriau, was engaged to build the boat in a much lighter construction than other 18s of the time.

According to Allan Walker, "the hull was moulded in a double diagonal laminate of fine red cedar on frames of spruce and ash. The end result was an extremely 'pretty' boat, small, very pleasing to the eye and light weight. Some extra strengthening was added later to reduce 'flexing' in the hull, producing a very stiff (and faster) hull."

"The three rigs were designed embracing knowledge that Hugh had garnered while sailing Flying Dutchman dinghies in Europe and Scandinavia. The rig set-up enabled controlled bending of the masts, which were rigged to minimise any side bend. Hugh designed and made all sails in his Blue Peter Sails loft."

Not long after the christening and launching of Thomas Cameron, it was realised that Sam Hatfield was not experienced enough for the task and he made way for a replacement, Ian Treharne, who became the jib sheet hand.

Allan Walker recalls, "Thomas Cameron immediately showed her potential, particularly after the rigs were raked further aft than the original setup. An unintentional benefit was that the clew of all jibs, when sheeted, ended up on the deck instead of three or four inches above. Hugh clearly recalls "how much 'nicer' the boat felt and the rakes were never altered again."

Kevin Flower left the crew suddenly, just prior to the 1970 Giltinan World Championship, which resulted in another crew change.

Walker says, "Phil Croll came on as jib sheet hand and Ian Treharne moved to forward hand. The rest is history with Thomas Cameron going on to win every subsequent scratch race, except one, when a spinnaker halyard broke during the 'worlds'. Even then we finished a close second to Willie B."

Rodney Pattisson, the English Flying Dutchman Olympic Gold Medalist, took the opportunity to take Thomas Cameron out for a race at the League while he was in Sydney on a short visit, and thoroughly enjoyed himself as he experienced the speed and ease of sailing the 'fantastic' boat.

Following a four-year 'retirement' from the 18s, Hugh Treharne was contacted by Carl Ryves, on behalf of Norman Booth, to see if he was interested in sailing a new 18 Footer to be sponsored by the Mosman GMH motor dealership, Norman G Booth Pty Ltd.

The boat was to race as Booth Holden.

Hugh and Ian Treharne and Allan Walker met to discuss the options. Walker remembers, "it had already been decided that the boat would be designed by Bruce Farr and Bill Barnett would be the builder. We had to decide on either a three-hand or a four-hand boat."

"We knew that everyone else was going three handers. We figured that Bruce Farr could provide the goods, and with our Thomas Cameron experience behind us, a four handed boat gave us a 'point of difference' to exploit. Knowing that multi Giltinan champion forward hand Hugh Cooke was available we decided on a four-hander."

"The boat was beautifully built by Barnett and it was immediately obvious that while all boats were 18 foot long, this was a 'big' beamy, fully chined boat, built in ply, and was a lot heavier than expected, and noticeably heavier than Thomas Cameron. Farr had designed a small skeg, built in forward of the rudder, because the hull was so wide and flat across the stern, that air cavitation was a likely issue."

Sail area had to compensate, and four rigs were designed to suit. The #1 mast measured 36 feet.

Hugh Treharne designed and made the sails. The sail areas were enormous for a centreboard skiff, however Walker re calls "despite the sail areas, we could never get the boat to 'pop' to windward. It always felt like we were sailing a yacht, albeit a very quick one. We even experienced this problem while test sailing 3-handed mid-week."

"We took the boat to Auckland for the 1974 worlds but fortune was not with us. During a bad set we wrapped a spinnaker around the rudder at the first mark in Race 1, then broke our #2 mast after rounding the first mark in Race 2."

"We had just completed a good spinnaker set, and with all of us out on the trapeze in 25-knots, and a big chop, the bow charged into the back of the wave ahead. Too big, too heavy, and nowhere to go, the boat stopped like it ran into a brick wall. The spinnaker, rig and all of us kept going over the bow."

Related Articles

The Vaikobi 18ft Skiff Team 2025
One of the young teams expected to be amongst the leading group this season One of the young teams expected to be amongst the leading group in the Australian 18 Footers League's 2025-26 season fleet on Sydney Harbour is the Vaikobi 18ft Skiff Team led by former Australian Cherub class champion Kirk Mitchell. Posted on 7 Sep
The Sixt 18ft Skiff Team 2025
Young team hoping for a more settled start to the 2025-26 season The young Sixt 18ft skiff team is hopeful a more settled start to the 2025-26 season at the Australian 18 Footers League, compared to the last-minute rush in 2024, and a third season together as a happy combination. Posted on 30 Aug
Bulwarks and Bulldust – Show 4 Season 2
Bulwarks and Bulldust welcomes Jack Macartney into the Captain's Chair This week Bulwarks and Bulldust speaks with Jack Macartney, legendary Australian sailor, Sydney to Hobart winner, RTW racer, 18-footer driver, and co-owner of Cannafox. Posted on 23 Aug
Bulwarks and Bulldust – Show 3 Season 2
Show Three of Season Two - Joel Turner of GC Sails - is now up and running This week Bulwarks and Bulldust speaks with Joel Turner, former Australian Sailing Team member in the 49er squad, and co-owner of GC Sails on the Gold Coast. Posted on 15 Aug
How the Australian 18 Footers League began
The evolution of Australia's leading 18 footer club As the Australian 18 Footers League (originally known as NSW 18 Footers Sailing League) prepares for the upcoming 2025-26 season, beginning with Race 1 of the Spring Championship on October 12, it's good to remember how the 'League' began in 1935. Posted on 13 Aug
Vaikobi Launches Custom Teamwear Program
To Elevate Team Identity and Performance Vaikobi, the world-renowned brand in performance watersports apparel, is proud to officially launch Vaikobi Custom Teamwear, a bespoke service designed to outfit teams, clubs, and businesses with high-quality, customised technical clothing. Posted on 7 Aug
Rockport Crew's 25th Year Reunion
Record-breaking 18ft Skiff team celebrate in London When England's Tim Robinson skippered Rockport to victory in the 1999 JJ Giltinan 18 footer Championship on Sydney Harbour, he set the record of becoming the first skipper from the Northern Hemisphere to win the coveted 18 footer championship. Posted on 29 Jul
New Zealand: 18 footer innovators
Strong contributors to the 18ft Skiff's evolution over the years David McDiarmid's Honda Marine 18 footer team had just completed its three-in-a-row winning run at the 2020 JJ Giltinan World Championship on Sydney Harbour when the Covid pandemic hit and suspended the New Zealand 18ft skiff challenge until 2024. Posted on 23 Jul
18ft Skiffs: Queensland 18 footer history
Decades of successful ideas and achievement Queensland's revival over recent seasons, which resulted in a two-pronged attack by experienced and young teams in new skiffs at the 2025 Giltinan world championship Posted on 2 Jul
18ft Skiff European Championships
Germany's Black Knight takes the title by a single point The International 18 Footer League - European Championship 2025, hosted by Circolo Vela Arco, concluded on Thursday, after five days of spectacular racing featuring some of the fastest and most exciting skiffs in the sailing world. Posted on 27 Jun
C-Tech 2021 America's Cup 728x90 BOTTOMPredictWind - Wave Routing 728x90 BOTTOMSea Sure 2025