sail-world.com -- The ten year sailing boat refit, and what to look for...

The ten year sailing boat refit, and what to look for...    

Based on your current download speed Sail-World has delivered images reduced in size (300 pixels long side). 
If you would prefer to see medium sized images (500 pixel long side) click here , or to view large images (660 pixel long side) click here.
If text only (without pictures) is your preference, click here


'Ten year refit - time to change your standing rigging'    .

Birthdays for people seem more relevant when you pass a new decade and have a 'big birthday'. Sailing boats are a little the same. Every ten years or so marks a time of change and renewal. Here BoatUS offers some hints about what you should look for in a major check every ten years:

Ten year refit - will that standing rigging last another leg? -  .. .   Click Here to view large photo
Standing and running rigging:

The ten year refit will, most importantly, include the standing rigging. When was the last time you had a close look at all of the fittings and mast attachments (even the ones up high)? Ten years (eight years for rod rigging) is a long time for rigging on boats that are engaged in long range cruising, but even those used for day sails can suffer from the cyclical loads that cause stress cracks, and saltwater can cause corrosion in swaged fittings not easily seen by the naked eye. As the loss of a mast at sea is not anyone's idea of a pleasant sail, the conservative view is that, at ten years, the standing rigging should be renewed. It is a good idea to check with your insurance company about their view on payouts for rigging failures as they age.

Ten year refit - where is the emergency plug? -  .. .  
Seacocks/Through Hulls:

The next most important issue is the skin fittings, as a faulty skin fitting can cause your boat to start sinking at the most unexpected time. If it's been years since one has been fully opened and closed, it could be frozen, and that's useless. Make it a point to work seacocks a few times each season and while you're there, check the hose clamps. Also make sure that the emergency plugs are all in place and haven't fallen away from beside the skin fitting, where they should be fastened.

Bilge pumps:

A ten-year old bilge pump has likely lead a tough life. Switches are often the first to go, so make sure yours works fine by pouring water in the bilge to activate the pump, making sure nothing interferes with the switch. Take a close look at wire connections as they often are near or in standing water at the bottom of the boat.

Fuel hose:

When it was new, the fuel hose did a great job of delivering fuel to the engine. Over time, however, fuel can permeate the hose wall causing damage. Take a rag around the hose, wipe it down and then smell the rag. If you smell fuel, replace hose immediately. If you do have to replace, always install new hose clamps, too.

Winches:

No doubt you have been regularly servicing your winches, but the ten year refit is a good time to check the bearings carefully.

Ten year refit - are the hoses and clamps in good condition? -  .. .  
Steering and control cable:

Like an arthritic knee, bend the cable in your hands and listen for 'crunching,' a telltale sign that all is not well. Swelling and rust are also bad signs and indicate it's time to replace.

Electrics:

The marine environment is not kind to any kind of electronics. Check all electrics for corrosion, with particular attention to the Nav lights as a safety feature.

Caulked fittings:

The boatyard rule of thumb is that after 10 years, the bedding compound owes you nothing. Begin a schedule to periodically remove and rebed fittings, doing a few each year so the job isn't overwhelming. This will keep the leaks out that could lead to more expensive repairs.

Prop:

Eventually all props get dinged, and you may not see the damage clearly with your eye. If it's never been to a shop, now is a good time to take it to a prop shop for reconditioning, and you'll also likely save some money on fuel with a tuned prop. It is particularly important to check feathering or folding props regularly. Check the alignment of the prop shaft.

Ten year refit - checking the propeller -  .. .   Click Here to view large photo

Other drive gear:

The cutlass bearing might be due for replacement, especially if there's more than just a smidgen of play in the drive shaft. It's also time to take a hard look at the stuffing box. If you've had to re-tighten the stuffing box nut often, it's time to replace the packing.

Engine:

Check that the engine mounts are not perished and are still functioning well. The heat exchanger should be taken apart to make sure there is no corrosion.

Keel bolts:

If you have keel bolts, this is a certain time to check them for corrosion.

Exhaust manifolds:

Unless you sail in fresh water, if you still have the original manifolds, thank your lucky stars they haven't failed yet. Now is the time to do some proactive maintenance to replace them. 'Leaking manifolds can destroy an engine,' said BoatUS Seaworthy Magazine Associate Editor Chuck Fort.

About Boat US: Boat Owners Association of The United States is an American association of boat owners offering various services and recreational boat and trailer towing activities. Among their services are boat insurance and boat loans, discounts on boating-related products and services, mediation services with manufacturers and dealers, a product recall alert registry, and lobbying organization on behalf of boat owners.

Did you like this article? Did you know that you can have all your non-competitive sailing news in one easy-read news magazine delivered direct to your inbox each week, simply by subscribing FREE to Sail-World Cruising? Stay up-to-date with what's happening on the water: everything from sailing adventures to new products, from rally news to new ideas and old tricks. Simply click here?nid=106391 now!



by BoatUS/Sail-World Cruising
- 12:54 AM Sat 9 Feb 2013 GMT





Click here for printer friendly version
Click here to send us feedback or comments about this story.
If you want to send this story to a friend, please use link below
http://www.sail-world.com/indexs.cfm?nid=106391

Based on your current download speed Sail-World has delivered large images (660 pixels long side.)  If you would like to see only small images (300 pixels long side) click here .  For medium sized images (500 pixels long side) click here .  If you would prefer to see text only (without pictures) click here

Click for further information on
Practical

Related News Stories:
05 Apr 2013  World's tiniest PLB now certified for use
27 Mar 2011  Low DSC connect rate:Sailor irresponsibility or technological failure?
18 Sep 2010  Sailor's aid or sailor's nightmare - the tides explained
05 May 2007  AIS - a major navigation advance
16 Jun 2006  The Necessary Sextant and How to Choose It
25 May 2006  Man Overboard! - See the Video
18 Apr 2006  Yachtmaster stable after flare explosion
23 Mar 2006  Seabrakes - a must have for offshore sailors?
12 Jan 2006  Retrieving your Anchor
01 Jan 2006  New Products 21DEC05

Switch Default Region to:

Social Media

Asia

Australia

Canada

Europe

New Zealand

United Kingdom


http://www.sail-world.com/event_images/image/Twitter_logo_small.png http://www.sail-world.com/event_images/image/FaceBook-icon.png  http://www.sail-world.com/event_images/image/RSS-Icon.png

United States

Cruising Northern

Cruising Southern

MarineBusiness World

PowerBoat World

FishingBoating World

 

Contact

Commercial

News

Search

Contact Us

Advertisers Information

Submit news/events

Search Stories/Text

Feedback

Advertisers Directory

Newsletter Archive

Photo Gallery

 

Banner Advertising Details

Newsletter Subscribe

Video Gallery

Policies

 

 

 

Privacy Policy

 

 


Cookie Policy

 

 



This site and its contents are © Copyright TetraMedia and/or the original author, photographer etc. All Rights Reserved.  Photographs are copyright by law.  If you wish to use or buy a photograph contact the photographer directly.
XLXL NEW AUS
LocalAds   DE  ES  FR  IT