News Home Video Gallery Newsletters Photo Gallery Cruising Int
Sail-World.com : Use This Sailing Safety Tool in a Flooding Emergency!
Use This Sailing Safety Tool in a Flooding Emergency!

'Make a simple seacock diagram. Divide the hull into thirds lengthwise to represent the forward cabin, main cabin, and cockpit/stern area. Place a dotted line down the middle to represent the centreline.'    .

The average sailing boat could have eight to twelve holes drilled below the waterline. These 'through-hulls' are used for heads, sink and shower drains, cockpit scupper drains, engine intake, instrument transducers, shaft exits and the rudder post. Each could be the source of a catastrophic ingress of water if they are not maintained. If the worst does happen, knowing precisely where they are and how to fix the problem quickly could save your boat.

Follow these easy steps to make sure your through-hulls do their job for peace-of-mind at the dock, at anchor, or when you're underway.

How to Avoid the Danger of Flooding
Most through-hulls are covered by a valve--called seacocks--with a handle that can be opened to allow sea water into the boat or shut to keep sea water out. Seacocks are the most important components beneath the waterline and need attention and care to prevent flooding. Check every handle on every seacock on every through-hull. Surveyors report time and again that they find frozen sea-cock handles on most every boat they inspect. You must be able to close any seacock with minimum effort.

Move the handle from open position (parallel to the hose) to closed position (perpendicular to the hose) and back to open. This exercises the seacock handle to keep corrosion at bay, and the handle lubricated. Open frozen seacock handles with a light tap from a hammer or mallet.

Examine the hoses at the top of each seacock. Replace hardened or cracked hoses right away. They are the number one cause of through-hull failure. Inspect the stainless clamps on each seacock hose. Replace rusted or corroded clamps. Double-clamp hoses on each side of a device or fitting. This adds extra security and peace-of-mind.

Insure that a tapered wooden plug gets lashed to the base of the seacock with easy-to-break twine. If a seacock hose fails, you can drive the plug into the seacock hole with a hammer or mallet as a temporary repair.

Mount a hammer or mallet nearby in brackets in a conspicuous location in the main cabin. Paint the handle day-glow orange or red. Add reflective tape strips to make it visible to a flashlight on the blackest night. Brief your sailing crew or partner. Instant accessibility could make a difference in keeping your boat afloat.

Inspect, clean, and lubricate every seacock once a year when you haul your boat. This gives you the perfect opportunity to find and fix problems. That way, you will have peace-of-mind that all of your through-hulls are in great shape for another sailing season.

Make a simple seacock diagram. Divide the hull into thirds lengthwise to represent the forward cabin, main cabin, and cockpit/stern area. Place a dotted line down the middle to represent the centerline. -  Captain John Jamieson  
Make a Simple Seacock Diagram
Make a Seacock Diagram for your boat (see illustration). You need to do this just once. If you add additional through hulls in the future, update your diagram. Post the completed diagram in the cabin so that all hands can see it.

Make another copy and insert it into your ship's papers notebook or briefcase. Spend a few minutes to go over the diagram with your crew so that they can locate any seacock aboard your boat within seconds.

1. Attach a piece of paper to a clipboard. Draw an outline of a hull (see illustration). Divide the diagram lengthwise into thirds as shown. These represent the forward cabin, main cabin, and cockpit/stern area. Make a dotted line down the center of the diagram from bow to stern to represent your boat's centreline. Strap a rubber band near the bottom of the clipboard to hold your diagram in place. Grab a pencil.

2. Start in the forward third of your boat (forward of the main cabin). Remove lockers, lids, or access covers to locate each seacock.

3. Plot small circles onto the diagram to indicate each seacock. Label each circle (head, shower, washdown hose, etc …) Note the dotted line down the centreline of the diagram. Seacocks should be plotted to the left, right, or along the centreline for faster access. Color code if desired (see illustration).

4. Include bilge cover plates. These can be difficult to locate in trying conditions because fine joinery work can make seams almost invisible.

5. Move to the midships section (main cabin); then to the aft section (cockpit and stern). Repeat the process. Print a second copy of the insert. Transfer your rough sketch onto the new insert so that it's neat and legible. Post it where all hands can see it day or night.

Note that not all through-hulls are covered by sea cocks. Include these locations on your diagram: shaft exit (where the propeller shaft exits the hull), rudder post location, fuel and water vents.

Use these easy sailing tips to keep your boat's 'gates to the sea' working to perfection--wherever in the world you choose to cruise!

John Jamieson (Captain John) with 25+ years of experience shows you the no-nonsense cruising skills you need for safer sailing worldwide. Visit his website at www.skippertips.com. Sign up for the Free, highly popular weekly 'Captain John's Sailing Tip-of-the-Week'. Discover how you can gain instant access to hundreds of sailing articles, videos, and e-Books!


by John Jamieson

  

Click on the FB Like link to post this story to your FB wall

http://www.sail-world.com/index.cfm?nid=105873

7:18 AM Fri 25 Jan 2013GMT


Click here for printer friendly version
Click here to send us feedback or comments about this story.







Cruising USA









World ARC crews in Bali by World Cruising Club,




Could your sailing navigation use a tune-up? by Captain John Jamieson, Florida






The Boat Cookbook by BoatBooks,








World ARC fleet now arriving in Bali by World Cruising Club,










Pack this sailing gear for 'hands-free' lighting by Captain John Jamieson, Florida
























A case of crossed wires? A shocking situation! by Stuart Carruthers, RYA Cruising Manager,






Boaters urged to attend anchoring meetings next week in Florida
New atlas provides thorough audit of marine life in the Southern Ocean
Canal Boating in the Alsace with the Galley Guys
World ARC fleet arrives in Darwin
Timeless Tonga - Charter sailing in a Polynesian paradise *Feature
A fine conclusion to the ARC Baltic 2014
Where in the world are our strongest corals?
Incredible efforts to save yacht from being lost at sea
ARC Baltic fleet visit six countries and six capitals in six weeks
Helen Island, Palau -a beautiful and unique place
Barnacle Busting
From Penguins to Polar Bears
Cornell turns back from the North West Passage
Polar research: Six priorities for Antarctic science
Missing German tourists in the hands of Abu Sayyaf Group
NCI granted dedicated VHF Channel
Positive news for cruising boats in Greece
Bivalves' ability to clean chemicals from waterways
Are You Sailing with 'Weak Links' in your sailing rigging?
Week-long cruise turns into 16-year round-the-world voyage
World ARC fleet cruising the Coral Coast   
Yacht penalized for calling unannounced into Port Resolution   
Galley Guys on the Malty Seas   
Blue Planet Odyssey - Beset in Arctic Bay ice + Video   
Garcia Yachts Exploration 45 - Jimmy Cornell's newest adventure   
Sustainable Seafood - How to purchase with confidence   
Risks to penguin populations continues   
ARC Baltic fleet head from Helsinki to Stockholm   
Follow these tips when anchoring   
Galley Guys meet the Spice Lady   
North American Rally to the Caribbean - Get prepared to head south   
If all else fails read the instructions!!   
ARC Baltic fleet cruising and anchoring in the Finnish archipelago   
Phuket Yacht Show: new kid on the block taking on PIMEX? *Feature   
Vanuatu Customs making life easier for visiting cruising yachts   
Baltic 4 Nations rally is now in full swing   
Tropical Storm Bertha expected to become a typhoon   
Flags at Sea, an infographic by John Tissott   
Cruising lessons from ocean racers   
Procedures set out for waterborne visitors to Vanuatu   


For this week's complete news stories select    Last 7 Days
   Search All News
For last month's complete news stories select    Last 30 Days
   Archive News







Sail-World.com  


















Switch Default Region to:

Social Media

Asia

Australia

Canada

Europe

New Zealand

United Kingdom


http://www.sail-world.com/event_images/image/Twitter_logo_small.png http://www.sail-world.com/event_images/image/FaceBook-icon.png  

United States

Cruising Northern

Cruising Southern

MarineBusiness World

PowerBoat World

FishingBoating World

 

Contact

Commercial

News

Search

Contact Us

Advertisers Information

Submit news/events

Search Stories/Text

Feedback

Advertisers Directory

Newsletter Archive

Photo Gallery

 

Banner Advertising Details

Newsletter Subscribe

Video Gallery

Policies

 

 

 

Privacy Policy

 

 


Cookie Policy

 

 



This site and its contents are © Copyright TetraMedia and/or the original author, photographer etc. All Rights Reserved.  Photographs are copyright by law.  If you wish to use or buy a photograph contact the photographer directly.
XLXL NEW Cru USA
LocalAds   DE  ES  FR  IT