Please select your home edition
Edition
Marine Resource 2016

Ten Tips on fendering to keep your topsides in good repair

by Des Ryan on 1 Dec 2012
Approaching the dock - do you have your fenders in the right position? .. .
The humble fender doesn't rate much as a news item, but the difference between the using a well-placed, right-sized fender and the wrong one can mean the difference between a damaged boat or a clean shiny hull. Here are some tips that I found invaluable in many thousands of miles of sailing

Docking Tips:


Tip 1. Make sure that each fender you attach is attached to something more solid than a life line. Examples are a the base of the rigging or sometimes a deck cleat. If you must attach it to a stanchion, make sure it is attached to the bottom end, and not the top, where it can put too much strain on the line and the stanchion.

Tip 2. Make sure that the knot you use to attach the fender is secure, but simple to do and undo. There are a number of reasons for this. First, if the dock you are heading for turns out to be at a slightly different height than you were expecting, you might need to change the positions of the fenders quickly. Secondly, sometimes you are asked to change from docking port-to to starboard-to or vice versa at the last moment because of changing conditions.

For attaching fenders over the side of a yacht, use a slippery clove hitch. If routing the line through a padeye or similar piece of hardware, change to a slippery half hitch with a long tail. There are some clever inventions on the market for quick tying and untying, the best of which are good quality hangers, which are very fast to attach and re-attach.

Tip 3. When positioning a fender in preparation for docking, the ideal level is just scraping the water. This is important so that it can't be pushed up by the movement of the boat against the dock, exposing your topsides to unwelcome damage.

Tip 4. Fenders should be positioned to protect the widest beam of the boat. A fender up near the bow or down near the stern can be useless unless you happen to have a helmsman who can't dock correctly.

Tip 5. Once the fenders are in place, an extra 'floating' fender, preferably a large flat one, can be used for inadvertant possible collisions during docking.

Tip 6. Don't depend on fenders on the dock. While it may be of assistance while docking that there are protective fenders along a dock, the fenders of most use to your boat are those that you place in strategic positions along your boat and that will ride up and down in the tide with you.

Tip 7. Don't use Polypropylene lines on fenders - they are slippery and innately insecure.

Tip 8. When rafting with another boat, the stationary boat should be treated as the dock. It will have its fenders out, but it is up to the rafting boat to ensure a smooth arrival.

Tip 9. Fenders are prone to rapid deterioration from UV. Covers are worth their weight on gold. It takes gold to buy the professional ones, but if there's someone handy on the boat, they are easy to make with stretchy material. The cover is also the first rubbing point, and will make your fenders last longer.

Tip 10. After docking it's good idea to tie both ends of the fender in place so that the bottom end is not now touching the water.


Finally, What kind of fenders are best?
Certainly you will need several cylindrical fenders suitable to the size of your boat. These are best for general docking, as their length is the most forgiving of discrepancies between the dock and your boat level. However, in addition, flat fenders are great as 'floating' fenders, which are excellent for warding off misbehaving or dragging boats. A big round fender (they are usually red) comes in extremely handy to protect your stern(dependent on its shape) if you are med mooring to a dock.... and don't forget the greatest of them all, the fender board (pictured, and very easy to make), for when you want to keep that barnacle encrusted dock a long way from your precious topsides.

Zhik Isotak Ocean 660x82Ancasta Ker 40+ 660x82Schaefer 2016 Ratchet Block 660x82

Related Articles

2014 J/24 World Championship - Will Welles’ Cougar clinches
Welles had used his throw-out on Thursday, so the only way to assure a win was to stay ahead. 2014 J/24 World Championship - With just a few points between Will Welles Cougar (USA) and Mauricio Santa Cruz Bruschetta (BRA) there was no room for error in the final two races of the 2014 J/24 World Championship hosted by Sail Newport.
Posted on 27 Sep 2014
J/24 World Championship - Will Welles hangs on going into last day
The Race Committee chose to sail inside north of the Newport Bridge for races seven and eight of the 2014 J/24 Worlds. With marginal conditions and diminishing visibility on the ocean course, the Race Committee chose to sail inside north of the Newport Bridge for races seven and eight of the 2014 J/24 World Championship hosted by Sail Newport. Will Welles’ Cougar (USA) sailed his throw-out in race seven but came back with a solid six in race eight to hold onto the lead with a total score of 31 points.
Posted on 26 Sep 2014
2014 J/24 World Championship - Will Welles holds advantage
After a struggle to set the line square to the shifting wind, the fleet got off two more races at 2014 J/24 World Champ 2014 J/24 World Championship - After a struggle to set the line square to the shifting wind, the fleet got off two more races at the 2014 J/24 World Championship hosted by Sail Newport. Will Welles’ Cougar (USA) held the lead with a four, four respectively for a total score of 16 points.
Posted on 25 Sep 2014
2014 J/24 World Championship - Will Welles takes lead
Teams battled today in more stable sea conditions on ocean course in wind speeds from 10 to 14 knots out of southwest. 2014 J/24 World Championship - After a morning postponement ashore, the fleet got off two more races at the 2014 J/24 World Championship hosted by Sail Newport. Will Welles’ Cougar (USA) moved to the lead with a nine, one respectively.
Posted on 24 Sep 2014
J/24 Worlds - Opening day leaves two teams tied on points for lead
Newport, Rhode Island welcomed 70 teams from around the globe with wind and waves on the first of five days 2014 J/24 World Championship - Newport, Rhode Island welcomed 70 teams from around the globe with wind and waves on the first of five days at the 2014 J/24 World Championship. The top of the fleet saw some familiar names but also some fresher faces. Mark Hillman’s Sokokumaru (USA) and Vernon Robert’s Gringa DC (Chile) are tied at five points, with Hillman having the first-place advantage thanks to
Posted on 23 Sep 2014
J/24 World Championship - 35th anniversary preview
Back in 1979, no one would ever imagine the J/24 class would achieve such enthusiastic support and popularity. Back in 1979, no one would ever imagine the J/24 class would achieve such enthusiastic support and popularity that in its first World Championships in Newport, RI, hosted by Ida Lewis YC and sponsored by Bacardi Rum, that 69 boats would participate in that event.
Posted on 20 Sep 2014
J/24 World Championship - Excitement builds for Newport racing
Seventy-one teams from 13 nations are registered to compete in the 2014 J/24 World Championship. The legend lives on 37 years after Rod Johnstone built the first J/24. Seventy-one teams from 13 nations are registered to compete in the 2014 J/24 World Championship in Newport, Rhode Island.
Posted on 19 Sep 2014
World's tiniest PLB now certified for use
Ocean Signal's rescueME PLB1, the tiniest PLB in the world, has now been certified for use in Europe and the USA The tiniest PLB in the world, introduced to the sailing world in January, has now been fully certified for use throughout Europe and the USA after being awarded relevant COSPAS-SARSAT and product approvals. The product will be available in Australia after being launched later this month.
Posted on 5 Apr 2013
Low DSC connect rate-Sailor irresponsibility or technological failure?
Is the low take-up of available DSC connection to radio because of sailor irresponsibility, or is it more complex? Recently we published a story about how few yachts had their Digital Selective Calling (DSC) equipped VHF radio connected to their GPS so that their position would be recorded in an emergency. The tone of the article suggested that the low take-up was an indication of the irresponsibility of sailors, but responses to Sail-World after the article suggest that the situation is more complex than this
Posted on 27 Mar 2011
Sailor's aid or sailor's nightmare - the tides explained
It's not surprising if you don't exactly understand tides - it took a lot of figuring out over the ages As sailors, we all know that tides come twice a day, vary according to the moon, and, depending on where you are sailing are either unimportant, reasonably important, or critically important to a successful completion of your voyage. But why the moon? and if the moon only circles the earth once a day, why are there two tides? Here, Grant Headifen of Nauticed, explains
Posted on 18 Sep 2010