sail-world.com
 
 
News Home Cruising Photo Gallery Video Gallery
Sail-World.com : Love your sailing boat's belts and they will love you in return
Love your sailing boat's belts and they will love you in return


'Tension should be ’just right’ in the belt'    .

When did you last replace the belts in your sailing boat's diesel engine? You didn't? Then you are waiting for the belt to snap just when you need it least. Let's face it, belts are not so expensive, and changing them regularly, rather than waiting until they snap, is the smart road to trouble free sailing.

Not that these belts - the alternator, auxiliary alternator, raw-water pump and circulator pump — won't typically provide really reliable and trouble-free service as long as they are properly maintained. But they do have a life, and replacing them on a sunny day in harbour is a comparatively pleasant job, compared with doing the same job in a lumpy sea when there's a crew, or worse, guests, wanting to get home.

The belts used to drive these accessories are of the 'V' variety or ribbon-shaped flat serpentine belts. Often, one V belt may do double duty, sending life from the crankshaft pulley to both the alternator and coolant pumps, while another belt will help drive the raw-water pump.

You can help elongate the life of a belt of course. One of the most important factors that affects belt life is making sure it is properly tensioned when it is installed, that the proper tension is maintained throughout its service life and it doesn't slip.

The regular inspection:
1. Check that the belts are tight — tight enough so they don’t slip, but no tighter. Follow the manufacturer’s recommendation for belt tension, don't just guess, or use old-fashioned 'rule of thumb' rules. If a belt is slipping, it won’t turn its related accessory properly, and it will wear out and break prematurely. If it’s too tight, it will accelerate wear on bearings and seals. If you see any evidence of belt dust on the front of the engine or the alternator casing, the belt is either slipping or misaligned. If the belt and/or pulley shows signs of glazing — a particularly smooth, shiny appearance — it means the belt is slipping. A glazed belt must be replaced, but the glaze on a pulley can be 'dressed' using 220-grit sandpaper.

Correcting the tension:
To tension a belt, use a breaker bar as a lever to pry the accessory away from the crankshaft pulley, and then tighten the fixing bolt. Threaded 'spreader' tools are available to make this task easier. Finally, ensure that each belt’s profile properly matches every pulley over which it turns. The belt should be even with, or stand slightly proud, no more than 1/16 inch, from the top of the pulley walls.

Self-adjusted tension and pulley bearings:
On engines with a single serpentine belt, tension is usually self-adjusted automatically via a spring-loaded tensioner. No additional adjustment is necessary. If this is the case, check the tension pulley bearing. When the belt is removed, the pulley must spin freely with no rough spots detected under hand pressure.

Continually replacing belts?
If this is the case, misaligned pulleys could be your problem. Alignment can be checked with a straightedge. If a pulley is bent or not on the same plane as the rest, the problem should be corrected, or the 'bad' pulley will continue to ruin belts.

Allowing a tired belt to keep working: Give your belts the break they need. Deteriorating belts can cause collateral damage to the alternator. A chronically slipping alternator belt can create large amounts of fine dust. The issue arises when this belt dust is drawn into the alternator with the cooling air. If the rubber dust-like debris makes contact with the hot components within the alternator, it will melt and adhere to them, creating a harmful insulating blanket coating the bearings, windings, diodes and heat sinks, potentially causing failure. Not a nice outcome!

How often should they be replaced?
As belts are pretty cheap in the scheme of things, it’s wise to replace them, say, during the annual check. Never leave them past 2,000 hours, whichever comes first. Having said that, it's also wise to replace them when you are embarking on a long voyage. But not JUST before you go, because in the first 50 to 100 hours of use the belt may need retensioning or some adjustment. So do it well enough in advance so that you can trouble-shoot before you leave.

Do all of the above and you are giving yourself the best chance of carefree sailing.


by Des Ryan/ Sail-World Cruising round-up

  

Click on the FB Like link to post this story to your FB wall

http://www.sail-world.com/index.cfm?nid=108463

1:49 AM Tue 16 Apr 2013GMT


Click here for printer friendly version
Click here to send us feedback or comments about this story.

Click for further information on
Practical

Related News Stories:

06 Apr 2013  Something to ponder - Is your GPS system 100% safe?
05 Apr 2013  World's tiniest PLB now certified for use
05 Apr 2013  World's tiniest PLB now certified for use
31 Mar 2013  Paper charts essential for the prudent sailor - or are they?
29 Mar 2013  Sail clear of these three dangerous wreck symbols!
29 Mar 2013  Paper charts essential for the prudent sailor - or are they?
16 Mar 2013  Getting your boat to shine in all weathers
12 Mar 2013  Secure attachment innovation iPad/iPhone for sailing boats
11 Mar 2013  T200 thermal camera - ideal for smaller sailing boats
10 Mar 2013  Use the Magic of S.T.O.P. for Safer Sailing Navigation
MORE STORIES ...






News - USA and the World





AWT Quatro Desert Showdown at Punta San Carlos by American Windsurfing Tour,






















America's Cup: Rod Davis - Time for a change after ten years with team *Feature by Richard Gladwell/Sail-World.com/nz,








Maxi yacht rendezvous this September in Sardinia by International Maxi Association,




















America's Cup: Team NZ wish Davis well with new team *Feature by Richard Gladwell, Sail-world.com/nz,


Fisher's View: Sailing perfection at Hamilton Island- Day 3 by Bob Fisher, Hamilton Island, Queensland




2014 Formula Kite World Championship Day 1 by Markus Schwendtner, Istanbul






52 Super Series - Fleet grows, 2015 dates revealed
420 and 470 Junior Europeans - Teams from 9 nations on the podium
IFDS Worlds - Former president presented with ISAF awards medal
Nanjing Youth Olympic Games - Improvements aplenty in Byte CII fleets
America's Cup: New Zealand loses top coach to Artemis Racing
Volvo Ocean Race 2014-15 CEO Knut Frostad talks (Part I) *Feature
Sevenstar Round Britain and Ireland Race Day 9 - Swish on record pace
2014 CORK Olympic Classes Regatta - Day 3
2014 Nanjing Youth Olympic Games - Day 2
2014 IFDS World Championship: Opening Ceremony images
Opera House Cup - Images by Ingrid Abery
Teams descend upon Cowes for inaugural J/111 World Championships
Hamilton Island Race Week: Everywhere there's smiley people
IFDS World Championships - US Paralympic hopefuls ready for racing
Sopot Match Race - Poland's Tour debut deemed a triumph
Vineyard Race celebrates 80th running of the East Coast classic
Nanjing Youth Olympic Games: Young sailors begin racing on Lake Jinniu
AWT Quatro Desert Showdown - Victory for Morgan Noireaux
Sevenstar Round Britain and Ireland Race - Day 8: Test of endurance
Bart's Bash: Over 2300 entered from 588 yacht clubs - Join here
Halifax ready to welcome the world at 2014 IFDS World Championships   
RC44 World Championship title to Bronenosec + Video   
Audi Hamilton Island Race Week: Day 2 Images by Crosbie Lorimer   
IFDS Worlds - Gary Jobson to attend opening ceremonies   
Melges 32 U.S. National Championship - Dalton DeVos crowned champion   
2014 Nanjing Youth Olympic Games trailer   
2014 Chicago Grand Slam - Canfield wins   
Round Britain and Ireland Race - Varuna takes overall lead   
Audi Hamilton Island Race Week; Crosbie Lorimer Day 1 Images   
Fisher's View: Hamilton Island Race Week - Day 1 - Stayin' Alive   
CORK Olympic Classes Regatta 2014 - Day one   
Youth Olympics: practice over, athletes welcomed, time for YOG sailing   
Round Britain and Ireland Race - Record for Artemis-Team Endeavour   
2014 Melges 32 U.S. National Championship - Day 2   
Sevenstar Round Britain and Ireland: Artemis sets fourth course record   
2014 Chicago Grand Slam - Top seeds survive as semi-finalists   
420 and 470 Junior Europeans - Breezy day 4 in Gdynia   
RC44 World Championship - Dramatic improvement for Artemis Racing   
18' Skiff International Regatta - Action begins August 25th   
Round Britain and Ireland Race - Challenging conditions arise   


For this week's complete news stories select    Last 7 Days
   Search All News
For last month's complete news stories select    Last 30 Days
   Archive News







Sail-World.com  


















Switch Default Region to:

Social Media

Asia

Australia

Canada

Europe

New Zealand

United Kingdom


http://www.sail-world.com/event_images/image/Twitter_logo_small.png http://www.sail-world.com/event_images/image/FaceBook-icon.png  http://www.sail-world.com/event_images/image/RSS-Icon.png

United States

Cruising Northern

Cruising Southern

MarineBusiness World

PowerBoat World

FishingBoating World

 

Contact

Commercial

News

Search

Contact Us

Advertisers Information

Submit news/events

Search Stories/Text

Feedback

Advertisers Directory

Newsletter Archive

Photo Gallery

 

Banner Advertising Details

Newsletter Subscribe

Video Gallery

Policies

 

 

 

Privacy Policy

 

 


Cookie Policy

 

 



This site and its contents are © Copyright TetraMedia and/or the original author, photographer etc. All Rights Reserved.  Photographs are copyright by law.  If you wish to use or buy a photograph contact the photographer directly.
XLXL NEW US
LocalAds   DE  ES  FR  IT